Starter strip
The edges get drip edge and starter shingles so water drips clear of the fascia.
Shingle Roofing
Shingle Roof Installation Millburn, NJ
A Millburn roofer can help you pick between 3-tab, architectural and impact-resistant shingles and install the full system beneath them, so the roof is sealed against wind-driven rain from the start. One call to (973) 858-1841 reaches a nearby roofer who installs shingle roofs.
Shingles are only the top layer of a shingle roof. The layers under the shingles include drip edge, ice and water shield, underlayment and starter strip, each with its own job. Flashing and attic ventilation round it out, and most leaks on newer roofs come from those details rather than the shingles.
Choosing the shingle comes before any of the layers. 3-tab shingles are thin and uniform, and architectural shingles are thicker laminated shingles with a textured, shadowed look and higher wind ratings. Where hail is a concern, Class 4 impact-resistant shingles are worth a look, and your insurer can tell you whether they change anything on your policy.
Pitch matters before anything is ordered. Asphalt shingles generally need a slope of at least 2 in 12, and roofs between 2 in 12 and 4 in 12 need extra underlayment. Porches and low additions often need a different material where they tie into the main roof.
Shingle Roof Installation is often paired with shingle roof replacement and roof installation, depending on the cause.
Dealing with this in Millburn, NJ right now? Call (973) 858-1841 to reach a nearby roofing contractor.
Call nowThe process
The order of a shingle installation
A shingle roof is built from the eaves up, layer over layer.
Prepare the deck
Sheathing has to be flat, dry and well fastened, so loose sheets are renailed and damaged ones replaced. A wet deck is never covered.
Seal the edges
Drip edge goes along the eaves, then ice and water shield runs up from the eave edge and down every valley. In cold climates the ice barrier extends past the inside of the exterior wall.
Cover the deck
Synthetic underlayment or felt is rolled out in overlapping rows from the bottom up, then drip edge goes on along the rakes over it. It is the backup layer if wind ever drives water past the shingles.
Starter strip
Starter shingles go on first at the eaves and rakes, putting a sealant line under the edge where wind lifts first. That is where wind damage usually begins on a poorly built roof.
Shingle the field
Each course is nailed in the nailing zone, never high or overdriven, and step flashing goes in piece by piece at every sidewall. Valleys are finished open with metal or closed-cut, depending on the shingle and the roof.
Ventilation at the ridge
The ridge gets a continuous vent and cap shingles, and the soffits are checked for open intake. Mixing ridge vents with box vents can short circuit the airflow.
What is included
What a new shingle roof includes
Flashing details
Step, counter and kickout flashing, pipe boots and a ridge vent are installed new so the details match the shingles.
Shingle selection
The roofer helps compare shingle types so the look and performance both fit.
Eave membrane
Self-adhering membrane is applied at the eaves and in valleys to seal around nails if water backs up.
Deck underlayment
The whole deck is covered with lapped underlayment so wind-driven rain has a backup.
Related service
Architectural Shingle Installation Millburn, NJ
Architectural shingle installation follows the same order as any shingle roof, but the shingle has its own rules. The nails must land in the narrow area where the two laminated layers overlap, or the bottom layer can slip and the wind rating is lost. Matching hip and ridge cap shingles and a compatible starter keep the look and wind rating consistent.
Most new shingle roofs in Millburn are architectural, and for good reason. Their weight and laminated build give them higher wind ratings and a longer life. Color is worth picking in daylight against the brick or siding, since samples look different outdoors.
Related service
Asphalt Shingle Roof Installation Millburn, NJ
An asphalt shingle roof installation is the most common way to roof a house, and the details decide how well it performs. Most early leaks on new shingle roofs come from flashing, nailing or missing starter, not from the shingles. Ask the roofer to explain the nailing pattern, the underlayment and how walls and valleys will be flashed.
A new asphalt roof in Millburn is usually installed in one to three days once the deck is ready. Shingles seal best in warm sun, so roofs installed in cold weather are often hand sealed along the edges. The crew will watch the forecast, since wet decking cannot be covered.
Local help
Shingle Roof Installation Near Me
In Millburn, asphalt shingles remain the most common choice for new residential roofs. Older homes in Millburn and nearby towns like Vauxhall, Springfield, Short Hills and Union often had felt underlayment and box vents, while new roofs usually get synthetic underlayment, ice barrier at the eaves and a ridge vent, so it pays to talk through wind ratings and impact resistance before choosing. Searching for shingle roof installation near me? Ask how the flashing and ventilation will be handled.
For shingle roof installation in Millburn, NJ or nearby towns like Vauxhall, Springfield, Short Hills and Union, call (973) 858-1841 to reach a roofer who covers your street.
What the local climate does to a roof
Winters here are long and cold, with snow on the roof for weeks at a time and plenty of nights below freezing. Heat escaping from the attic melts snow on the upper roof, and the water refreezes at the colder eaves, building ice dams that push water up under the shingles. Coastal storms and heavy spring rain drive water sideways into flashing, valleys and old chimneys. Most homeowners in Millburn, NJ have the roof checked in the fall and again after the snow melts.
Why call
Why not wait
Less damage
A roof problem fixed early rarely spreads to the decking, the insulation or the ceilings.
Local knowledge
Roofers in Millburn know the roof types and weather wear common in local homes.
Clear next steps
Ask your questions before you agree to anything.
Common questions about shingle roof installation
What goes under the shingles on a new roof?
Starting at the deck, a new roof gets drip edge, ice and water shield at the eaves and valleys, underlayment over the rest and a starter strip at the edges. Synthetic underlayment has largely replaced felt because it is lighter, stronger and less likely to wrinkle or tear. Local code decides where ice barrier is required.
How steep does a roof need to be for shingles?
Asphalt shingles need a slope of at least 2 in 12. Roofs that are low but still within range get added underlayment protection. Porches and additions below that line need a low slope material.
What is the difference between 3-tab and architectural shingles?
The difference is construction: one flat layer for 3-tab, two laminated layers for architectural. The thicker build gives architectural shingles better wind resistance and a longer life, and many lines no longer offer 3-tab. 3-tab still works for sheds, garages or matching an existing roof.
Can shingles be installed in cold weather?
Warm, dry days give the best results for a shingle install. Winter installs are possible, but the shingles need gentle handling and the sealant may not bond until warmer days. Wet decking is the hard stop at any time of year.
Why does nail placement matter on a shingle roof?
Nail count and placement decide how well shingles stay on in wind. Standard nailing uses four nails, and high-wind areas often require six. High or overdriven nails are a leading cause of blow-offs on newer roofs.
More questions? Call (973) 858-1841
Often needed together
Shingle Roof Replacement
Full shingle roof replacement, from tear-off and deck repair to new shingles and flashing, including permits, cleanup and a final check.
Learn moreRoof Installation
New roof installation done in the right order with the right details, with ventilation and flashing planned in from the start.
Learn moreRoof Ventilation
Balancing attic intake and exhaust with soffit vents, ridge vents and attic fans, based on what the attic actually needs.
Learn moreGutter Installation
New gutters and downspouts formed to fit the house, with the right size, pitch and outlet placement, from K-style aluminum to half-round and copper.
Learn more
Looking for something else?
See all roofing servicesNeed shingle roof installation in Millburn, NJ?
Call now for Millburn shingle roof installation and help in the towns around it.